ASSESSMENT OF THE INFLUENCE OF INORGANIC PIGMENTS ON THE TECHNOLOGICAL PROPERTIES OF DECORATIVE CEMENTS

Abstract

The article presents the results of research on the influence of inorganic pigments on the technological properties of decorative cements. It has been established that regardless of the color of the pigment, with an increase in its quantity in the system, we get a more saturated and bright color of cement stone, but at the same time there is a negative effect of pigments and technological and physical and mechanical properties of artificial stone. The research was conducted on cement systems based on white Portland cement without additives and on cement systems based on white Portland cement modified with polycarboxylate superplasticizer. An increase in the amount of pigment, regardless of its color, leads to an increase in the water consumption of the cement system, however, when a superplasticizer is introduced, the effect of the pigment is not so significant. At the same time, the introduction of a superplasticizer reduces the water consumption of white cement without the introduction of pigments by an average of 37-40%. In addition, it was established that the introduction of pigments affects the hardening time of cement systems. At the same time, pigments, depending on their color and dosage, have different effects on both the start and end of aging. With an increase in the pigment content in a cement system without a plasticizer, the time of the onset of hardening increases, and the introduction of a permanent pigment has the greatest effect on the end of hardening of such a system. The introduction of pigments into plasticized cement systems increases both the start and end time of hardening. As the number of pigments of all colors increases, the strength of the samples decreases. At the same time, the red pigment leads to the greatest decline in strength at all stages of hardening. The decrease in strength can be explained by the increased water consumption, and, as a result, the increased porosity of pigmented samples compared to samples without the introduction of pigments. Further research aimed at finding additives that will reduce the negative impact of inorganic pigments on the processes of hydration and hardening of the cement system, and therefore on the durability of the obtained artificial stone, will be relevant. At the same time, it is important to preserve the intensity of the color and the absence of sediment formation.